FL Permit Practice Test 4

All 20 questions in test 4

Every question below comes from the Florida question bank on this page. Open a question to see the correct answer and the explanation. Nothing here is hidden behind a signup.

1. 1. If a WRONG WAY sign is facing you, what does it tell you about your vehicle's direction?

   1. Trucks must use a different lane ahead
   2. The roadway ahead has a rough surface
   3. You are traveling against the permitted direction and should turn around immediately
   4. A legal passing zone is beginning
   Show answer

   You are traveling against the permitted direction and should turn around immediately. A WRONG WAY sign means the vehicle has entered a roadway in the prohibited direction. The handbook directs the driver to turn around immediately, but that maneuver must still be made safely and legally. The rough-surface choice confuses a directional command with a roadway warning, and the truck choice has no connection to the sign. Seeing this red message is an urgent cue to stop following the route and correct direction before meeting opposing traffic.

2. 2. What direction must traffic follow when this ONE WAY sign is posted?

   1. Either direction, provided the driver stays in the right lane
   2. The opposite direction during off-peak hours
   3. Only the direction shown by the arrow
   4. Only buses may follow the arrow
   Show answer

   Only the direction shown by the arrow. A ONE WAY sign limits travel to the direction indicated by its arrow. It is a legal direction control, so a driver cannot reverse direction simply because traffic is light or because the opposite lane appears open. The right-lane choice confuses lane position with roadway direction, and the bus choice invents a vehicle exception. Before entering, compare the arrow with the intended route. If the route does not match, continue to a legal place to turn around rather than entering against traffic.

3. 3. What movement is prohibited by a NO U-TURN sign?

   1. Making a complete turn to travel in the opposite direction
   2. Turning left into a side street
   3. Passing another vehicle on a two-lane road
   4. Turning right at the next intersection
   Show answer

   Making a complete turn to travel in the opposite direction. NO U-TURN prohibits the maneuver that reverses the vehicle’s direction through a complete turn. It does not automatically ban every left turn, passing movement, or right turn. The left-turn distractor is attractive because both maneuvers use steering toward the left, but the sign targets the full reversal, not an ordinary turn into another road. Identify whether the intended path returns the vehicle in the opposite direction. If so, choose another legal route or intersection.

4. 4. What maneuver is banned by the NO LEFT TURN sign?

   1. Making a U-turn at any later intersection
   2. Continuing straight through the intersection
   3. Turning right after yielding to pedestrians
   4. Turning left at the controlled intersection
   Show answer

   Turning left at the controlled intersection. The red slash over a left-turn symbol prohibits the left-turn movement at that location. It does not by itself prohibit going straight, turning right, or making a U-turn somewhere else where that movement is lawful. The U-turn option changes both the maneuver and the location, which is why it does not answer the sign. Trace the pictured arrow in your mind: when it points left and is crossed out, do not steer into the left-turn path. Follow another permitted movement instead.

5. 5. What movement is prohibited by the NO RIGHT TURN sign, including when the signal is red?

   1. Driving straight through the intersection
   2. Parking on the right side of the roadway
   3. Turning right at that intersection
   4. Turning left after yielding to traffic
   Show answer

   Turning right at that intersection. NO RIGHT TURN bans the right-turn movement at the marked intersection. A driver may not make that turn simply because the signal is red or because the route appears clear. The straight-ahead choice is not prohibited by this symbol, and parking position is unrelated to the intersection movement. The left-turn option describes a different path. Match the symbol to the planned maneuver before entering the intersection, then select a permitted direction and obey any other signal control.

6. 6. What does a posted Speed Limit sign tell a Florida driver?

   1. The number is only a suggested speed for clear weather
   2. The driver may exceed it while passing another vehicle
   3. The sign applies only to commercial vehicles
   4. The vehicle must not exceed the posted speed in that area
   Show answer

   The vehicle must not exceed the posted speed in that area. A Speed Limit sign gives the maximum lawful speed for the area. It is not merely advice for favorable weather, and passing does not create permission to exceed it. The commercial-vehicle choice wrongly narrows a rule that applies to drivers generally. Road, weather, visibility, and traffic may require an even lower speed, but none of those conditions raise the posted maximum. Read the number as a ceiling, then reduce speed whenever conditions make that ceiling unsafe.

7. 7. When a KEEP RIGHT sign marks a divider, where should you drive?

   1. To the left of the divider unless passing
   2. Across the divider when traffic is light
   3. In the shoulder beside the divider
   4. To the right of the divider
   Show answer

   To the right of the divider. KEEP RIGHT directs the driver to remain on the right side of the divider. The divider may separate traffic or mark an obstruction, so crossing it defeats the sign’s purpose and can put the vehicle into a conflicting path. The passing choice treats a fixed traffic control as a temporary lane preference. Reduce speed if needed, identify the divider early, and guide the vehicle around its right side while staying in the designated travel lane.

8. 8. What right-of-way rule applies at the railroad crossing marked by a crossbuck?

   1. Yield the right-of-way to trains
   2. Proceed first if the train is still far away
   3. Stop only when a gate is lowered
   4. Treat the sign as a lane-direction marker
   Show answer

   Yield the right-of-way to trains. A railroad crossbuck functions as a yield sign for trains. Slow down, look for approaching rail traffic, and be ready to stop so the train receives priority. The gate-only option misses crossings that use a crossbuck without a lowered gate, while distance is not a license to race across the tracks. Scan both directions and make sure the route beyond the rails is open before proceeding. The X shape identifies the crossing, but the required action is yielding to the train.

9. 9. What does the round yellow railroad warning sign tell a Florida driver?

   1. A roundabout is ahead and traffic moves counter-clockwise
   2. A highway-railroad crossing is ahead, so slow and prepare to stop
   3. The railroad crossing has already been passed
   4. Bicycles are prohibited on the roadway
   Show answer

   A highway-railroad crossing is ahead, so slow and prepare to stop. The round yellow railroad symbol is advance notice of a highway-railroad crossing. It gives the driver time to reduce speed, scan the tracks, and prepare to stop before reaching the crossing. The roundabout choice relies only on the shape and ignores the railroad symbol. Do not wait for gates or lights before becoming alert. Treat the sign as an early warning, then approach slowly enough to stop if a train, signal, gate, or flagger requires it.

10. 10. What area or activity does the five-sided school sign identify?

    1. An adult pedestrian-only recreation area
    2. A railroad station crossing
    3. A public park with no special traffic rule
    4. A school area where drivers should watch for children
    Show answer

    A school area where drivers should watch for children. The school sign means the driver is near a school and must watch for children at all times, not just during school hours. The park and adult-crosswalk choices mistake the sign’s purpose, while the railroad option belongs to a different warning family. Reduce speed when conditions call for it, watch the roadside and crossings, and be ready for children whose movements may be unpredictable. The five-sided shape is a useful visual cue for school-related activity.

11. 11. What should a driver do after seeing a pedestrian crossing warning sign?

    1. Speed up before pedestrians reach the roadway
    2. Continue without changing speed because the sign bans pedestrians
    3. Move into the opposing lane to avoid the crossing
    4. Slow down and stop to yield for pedestrians when necessary
    Show answer

    Slow down and stop to yield for pedestrians when necessary. A pedestrian crossing warning calls for attention to people crossing the street. Slow down and be prepared to stop so pedestrians can receive the right-of-way when necessary. The sign does not prohibit pedestrians, and speeding toward the crossing increases risk. Moving into opposing traffic creates a separate danger and is not the prescribed response. Look for people near the roadway, cover the brake, and leave enough space to stop smoothly rather than relying on the warning sign to clear the crossing for you.

12. 12. What hazard does a TRAFFIC SIGNAL AHEAD warning sign identify?

    1. A police checkpoint where all vehicles must stop
    2. A traffic signal at the intersection ahead
    3. A broken streetlight that should be reported
    4. A lane reserved for emergency vehicles
    Show answer

    A traffic signal at the intersection ahead. The warning sign announces that a traffic signal is located at the intersection ahead. It gives the driver time to slow down, especially when poor visibility may make the signal difficult to see until the last moment. The checkpoint and streetlight choices confuse a traffic-control warning with unrelated conditions. Begin observing the roadway, traffic, and signal as soon as the sign appears. Do not accelerate to beat the light; approach at a speed that allows a safe response if it changes.

13. 13. How should a driver respond to a STOP SIGN AHEAD warning?

    1. Stop immediately beside the warning sign
    2. Slow down and be ready to stop at the upcoming stop sign
    3. Ignore it if the intersection appears empty
    4. Turn around before reaching the intersection
    Show answer

    Slow down and be ready to stop at the upcoming stop sign. STOP SIGN AHEAD warns of a stop sign farther along the roadway. Slow down early and prepare to make the complete stop at that upcoming control. Stopping beside the warning sign may block traffic and does not satisfy the later stop requirement, while an empty intersection does not cancel a stop sign. Use the warning to locate the next control, release speed gradually, and arrive able to stop at the line, crosswalk, or proper stopping point.

14. 14. What roadway condition is announced by a MERGING TRAFFIC warning sign?

    1. Another traffic lane joins the lane you are using
    2. Your lane is reserved for buses only
    3. All traffic must stop before changing lanes
    4. The roadway ahead prohibits any merge
    Show answer

    Another traffic lane joins the lane you are using. MERGING TRAFFIC warns that another lane will join the one being used. Watch for vehicles entering, adjust speed and spacing, and yield the right-of-way when necessary. The bus-lane choice invents a vehicle restriction, while stopping all traffic is not the normal response to a merge warning. Look beyond the sign for the joining lane and keep a safe opening. The goal is a smooth, predictable merge that avoids forcing another driver to brake or swerve.

15. 15. What should you do when a LANE ENDS sign warns that your lane will disappear?

    1. Continue in the ending lane until the pavement stops
    2. Stop immediately in the lane and wait for a gap
    3. Merge into the remaining lane when safe
    4. Use the shoulder as the new travel lane
    Show answer

    Merge into the remaining lane when safe. A lane-ends warning means traffic in that lane must merge into the lane that continues. Check mirrors, signal, adjust speed, and move over when a safe opening is available. Continuing until the pavement ends creates a sudden conflict, while stopping in a travel lane or using the shoulder adds risk. Look for drivers in the continuing lane and make your intention predictable early. The sign is an advance cue to arrange the merge, not permission to force other traffic aside.

16. 16. What should a driver expect after seeing the two-way traffic warning sign?

    1. The divided highway will continue with no opposing traffic
    2. The roadway will change to two-way traffic with oncoming vehicles
    3. All passing will be allowed in both directions
    4. The next lane will be reserved for emergency vehicles
    Show answer

    The roadway will change to two-way traffic with oncoming vehicles. This warning marks a change from one-way or separated travel to a roadway where vehicles approach from the opposite direction. A driver should reduce speed, keep right, and scan ahead for oncoming traffic before considering any maneuver. The divided-highway choice reverses the sign's message because separation is ending or absent. The passing choice is unsafe because the warning says nothing about permission to pass, and the emergency-lane choice invents a restriction unrelated to the symbol. Think of the opposing arrows as a preview of traffic coming toward you in the same roadway.

17. 17. What does the divided highway ahead warning sign tell a driver?

    1. The divided highway ends and two-way traffic begins immediately
    2. The highway ahead is divided by a median or physical barrier
    3. A roundabout is ahead with traffic moving in one circle
    4. The road narrows to one lane in the driver's direction
    Show answer

    The highway ahead is divided by a median or physical barrier. The split arrows represent traffic separated by a median or another physical barrier farther ahead. The driver should prepare for the roadway arrangement and follow lane markings as the separation begins. The choice saying the divided highway ends describes a different warning and would put the driver on the wrong side of the sign's meaning. A roundabout has circular advance guidance, while a one lane reduction concerns merging rather than opposing flows. Use the sign as an advance cue to watch for the median and maintain the proper side of travel.

18. 18. When the slippery surface warning sign appears, which response follows the handbook?

    1. Accelerate firmly so the tires clear the wet surface
    2. Use hard braking before every curve to test traction
    3. Drive slowly in wet weather and avoid speeding or quick braking
    4. Treat the sign as notice of a gravel-only roadway
    Show answer

    Drive slowly in wet weather and avoid speeding or quick braking. The skidding vehicle warns that wet pavement can reduce traction. The handbook advises a slow speed and cautions against accelerating or braking quickly, so the driver has more time to respond smoothly. Acceleration can increase the chance of a skid, and hard braking is the opposite of the gentle control needed on a slick surface. The gravel-road choice confuses this warning with a pavement-ends condition. A useful cue is to pair the sign with rain: ease off the accelerator, leave room, and make turns slowly.

19. 19. What action is recommended at a right curve warning sign?

    1. Slow your speed and do not pass other vehicles
    2. Turn only at the next intersection
    3. Increase speed before entering the bend
    4. Move onto the shoulder to complete the curve
    Show answer

    Slow your speed and do not pass other vehicles. A right curve warning describes the road's path and gives the driver time to prepare. The handbook specifically pairs this sign with slowing down and refraining from passing, since sight distance and control can be limited through the bend. Increasing speed reduces the margin for steering or braking. The intersection choice treats a curve as a junction, and using the shoulder is neither a normal lane choice nor a safe response. Reduce speed before the curve so the vehicle remains stable while following the roadway.

20. 20. What does the sharp right turn warning sign indicate?

    1. The road will make a sharp turn to the right; slow down and do not pass
    2. The roadway will curve gently left with passing encouraged
    3. A one-way street begins at the next block
    4. A right turn is prohibited at the upcoming intersection
    Show answer

    The road will make a sharp turn to the right; slow down and do not pass. The right-angle arrow signals a sharper change in direction than an ordinary curve warning. The manual tells drivers to slow down and avoid passing other vehicles, which protects control and sight distance around the turn. The gentle-left choice changes both direction and severity. Nothing in this symbol announces one-way travel or bans a turn at an intersection. Read the arrow as a road alignment warning, then lower speed before the turn rather than braking late while steering through it.