IN Permit Practice Test 2

All 20 questions in test 2

Every question below comes from the Indiana question bank on this page. Open a question to see the correct answer and the explanation. Nothing here is hidden behind a signup.

1. 1. What do warning signs do for a driver?

   
   1. Prepare the driver for upcoming road conditions and hazards
   2. Authorize the driver to exceed the posted speed limit
   3. Guarantee that the road ahead is free of pedestrians
   4. Replace all traffic signals at the next intersection
   Show answer

   Prepare the driver for upcoming road conditions and hazards. Warning signs prepare drivers for road conditions and hazards that are coming up. They do not grant permission to speed, promise that the roadway is clear, or replace a signal. A driver should use the advance notice to adjust speed, position, and attention before reaching the condition shown. For example, a pedestrian or slippery-road symbol calls for active scanning and smooth control. Treat the warning as an early cue, then obey the separate regulation, signal, or person controlling traffic at the location.

2. 2. Unless posted otherwise, what is the speed limit for passenger vehicles on an Indiana rural interstate?

   1. 55 mph
   2. 60 mph
   3. 70 mph
   4. 65 mph
   Show answer

   70 mph. On rural interstates, outside urban areas of at least 50,000 people, passenger vehicles may not exceed 70 mph or the posted limit. Trucks with a declared gross weight above 26,000 pounds are held to 65 mph. Sixty mph is the rural state divided highway limit, and 55 mph is the urban interstate limit. Drivers must still slow down when conditions make those speeds unsafe.

3. 3. What is the maximum width of a vehicle that may operate on Indiana public highways without a special permit?

   1. 7 feet 6 inches
   2. 8 feet
   3. 8 feet 6 inches
   4. 10 feet
   Show answer

   8 feet 6 inches. Indiana's tractor trailer section lists 8 feet 6 inches as the maximum width for a vehicle operating without a special permit. The eight foot choice omits the additional six inches, while 7 feet 6 inches is smaller and 10 feet exceeds the stated limit. This measurement concerns the public highway equipment limit, not the width of an ordinary lane. Keep the three dimensions separate when studying: width is 8 feet 6 inches, height is 13 feet 6 inches, and weight is 80,000 pounds.

4. 4. What should an Indiana driver do when approaching an intersection whose traffic signal is not operating?

   1. Continue through without slowing
   2. Wait until the signal turns green
   3. Stop only if other traffic is approaching
   4. Stop before entering the intersection, then proceed with caution
   Show answer

   Stop before entering the intersection, then proceed with caution. A dark or broken signal is treated as a stop in Indiana. Stop before entering the intersection, look in every direction, yield to traffic and pedestrians who are already there, and proceed only when it is safe. Driving through without slowing assumes cross traffic will stop for you, which it may not. Stopping only when someone is coming misses the pedestrians and the vehicles hidden by buildings, and waiting for a signal that is not working could take hours. Treat it like a four way stop.

5. 5. When approaching a roundabout, incoming traffic must:

   
   1. Enter first and make circulating traffic stop
   2. Travel clockwise around the island
   3. Yield to traffic already circulating
   4. Stop in the center of the circle
   Show answer

   Yield to traffic already circulating. Traffic approaching a roundabout yields to vehicles already circulating. The circulating roadway moves counterclockwise, and entering traffic should not stop in the center island or force vehicles already in the circle to brake. Look left for a safe gap, yield as required, and follow the marked lane through the circle. The main visual cue is the yield line at the entrance. The vehicle already in motion around the circle has priority over the vehicle waiting to enter.

6. 6. How far behind a disabled vehicle should a red emergency reflective triangle normally be placed on the roadside?

   1. Exactly 1,000 feet regardless of the road
   2. 50 feet in every location
   3. 100 feet unless the vehicle is on a divided highway
   4. 200 feet, or 500 feet on a hill or curve
   Show answer

   200 feet, or 500 feet on a hill or curve. Indiana's roadside emergency guidance places a red emergency reflective triangle 200 feet behind the disabled vehicle under ordinary conditions. If the vehicle is on a hill or curve, the distance increases to 500 feet so approaching motorists have more warning before reaching the obstruction. Fifty feet gives too little advance notice, and the 100-foot alternative belongs to other warning-device rules. The manual does not create a universal 1,000-foot placement. First identify whether the roadway shape limits visibility, then use the longer placement when needed.

7. 7. What are Indiana police officers legally required to do after every traffic stop?

   1. Document the stop, including obtaining the driver's name and address for data collection
   2. Search the vehicle
   3. Issue a written warning
   4. Report it to the BMV within 24 hours
   Show answer

   Document the stop, including obtaining the driver's name and address for data collection. Regardless of what action is taken, police officers are legally required to document all traffic stops, which includes obtaining the driver's name and address for data collection purposes. If you believe an officer acted improperly, complaints can be filed with the agency's internal affairs division or a civilian complaint board rather than argued at the roadside. Keep the encounter calm and cooperative, and sign the ticket if one is issued.

8. 8. Which information may a rectangular traffic sign convey?

   1. Traffic regulations that drivers must obey
   2. The private ownership of a roadway
   3. A driver's medical history
   4. The age of the nearest vehicle
   Show answer

   Traffic regulations that drivers must obey. A rectangular traffic sign may convey a traffic regulation that drivers must obey, including a speed limit or a turn movement prohibition. The other choices describe private or personal information that traffic signs do not communicate. Rectangular signs can also provide helpful route information and warn about hazardous conditions, but the regulation category is enough to answer this question. When reading one, focus on its words and symbols rather than assuming every rectangle has the same instruction. A speed limit panel is a familiar example of this sign function.

9. 9. What share of fatal crashes nationally involve a fatigued driver, according to Indiana's manual?

   1. About 2 percent
   2. An estimated 17.6 percent
   3. About 50 percent
   4. About 90 percent
   Show answer

   An estimated 17.6 percent. Nationally, an estimated 17.6 percent of all fatal motor vehicle crashes involved a fatigued driver. Going 18 hours without sleep leaves a driver as impaired as one at the 0.08 legal alcohol limit. Shift workers, parents of young children, and young adults are most at risk. Stop driving if you catch yourself yawning, drifting, or unable to remember the last few miles.

10. 10. What does a yellow pennant-shaped traffic sign warn drivers about?

    1. A nearby fuel station
    2. A railroad crossing
    3. A no passing zone
    4. A school entrance
    Show answer

    A no passing zone. The pennant shape is used on the left-hand side of a two-way road to warn that drivers should not pass other vehicles on the left. A fuel service sign is an information sign, a railroad crossing uses a circular warning shape, and a school area uses a five-sided shape. Read both the shape and placement together. The left-side pennant is a strong visual cue that the roadway is entering a no passing zone.

11. 11. How close to a railroad crossing is passing prohibited under Indiana's listed passing rules?

    1. Within 25 feet
    2. Within 250 feet
    3. Only on the tracks themselves
    4. Within 100 feet
    Show answer

    Within 100 feet. Indiana lists railroad crossings among locations where passing is prohibited within 100 feet. That buffer applies before the crossing, when sight lines and the crossing environment demand extra attention. Twenty-five feet is shorter than the stated distance, while 250 feet is not the figure given. Waiting until the vehicle is physically on the tracks would defeat the safety purpose. Scan for the crossing early, remain in your lane, and do not begin a passing maneuver inside the 100-foot approach area.

12. 12. Before making a permitted right turn through a solid red light, what is required first?

    1. Roll through after checking the left mirror
    2. Wait for a green arrow in every case
    3. Come to a full stop
    4. Turn immediately if the cross street is empty
    Show answer

    Come to a full stop. Indiana requires a full stop before a permitted right turn through a red light or arrow. After stopping, the driver still checks for vehicles and pedestrians in the turn path, looks for a No Turn on Red sign, and uses the correct lane. Rolling through after checking a mirror is not a full stop, and an empty cross street does not remove that requirement. A green arrow is not required in every permitted right-turn situation. Treat the red signal as a complete pause, then perform the remaining safety checks before entering the intersection.

13. 13. What do yellow or fluorescent yellow-green traffic signs prepare a driver to notice?

    
    1. Road services and amenities at an upcoming exit
    2. Recreational and cultural interest sites
    3. Only legal speed limits and turn prohibitions
    4. Specific road conditions, hazards, and nearby school zones
    Show answer

    Specific road conditions, hazards, and nearby school zones. Yellow and fluorescent yellow-green signs alert drivers to conditions, hazards, and school areas ahead. The fluorescent version can identify nearby schools, pedestrians, bicycles, playgrounds, and school bus routes, so the driver should reduce distractions and scan carefully. Blue signs provide road services, brown signs identify recreation or cultural sites, and white signs display regulations such as speed limits. The key cue is the warning color: expect something about the roadway or people near it, then adjust speed and attention before reaching the location.

14. 14. When fog reduces visibility to near zero, where should an Indiana driver take the vehicle?

    1. To the shoulder and stop as far off the road as possible
    2. Onto the center line with hazard lights off
    3. Through the fog at the posted speed
    4. Into the left lane with high beams on
    Show answer

    To the shoulder and stop as far off the road as possible. If fog closes in completely and visibility is nearly zero, the manual directs the driver to carefully pull off the road as far as possible and stop. High beams make fog visibility worse, and continuing at the posted speed ignores the severe loss of sight distance. The center line is not a refuge and creates a collision risk. The cue is near zero visibility, which changes the task from simply slowing down to leaving the travel path safely.

15. 15. How many points does Indiana assess for driving while suspended?

    1. 2 points
    2. 4 points
    3. 6 points
    4. 8 points
    Show answer

    8 points. Driving while suspended carries 8 points, the highest value on the Indiana examples list, shared with a speed contest on the road. Six points apply to following too closely and failing to yield to an emergency vehicle. Two and four points apply to lesser violations. A prior offense for driving while suspended can also lead to a misdemeanor or felony conviction.

16. 16. After a change to personal information other than address, how soon must an Indiana credential be amended?

    1. Within 10 days, online
    2. Within 30 days, at a BMV branch with documents
    3. Within one year
    4. At the next renewal
    Show answer

    Within 30 days, at a BMV branch with documents. If any information other than the address has changed, you cannot order a replacement online and must visit a BMV branch to amend your credential within 30 days of the change, presenting the documents listed in Appendix A. Name changes must first be made with the Social Security Administration, allowing at least one business day before visiting the branch. Address changes also require branch documents.

17. 17. What suspension period does Indiana list for a motorist who fails a chemical test?

    1. 30 days
    2. 180 days
    3. One year
    4. Two years
    Show answer

    180 days. Failing a chemical test in Indiana brings an administrative suspension of driving privileges for 180 days, separate from whatever the court later imposes for the offense itself. Thirty days is too short to match anything in the manual, and one or two years are lengths reserved for repeat or habitual offenders. The suspension follows the test result rather than the conviction, which is why it can begin before the case is heard. Refusing the test carries its own, longer suspension.

18. 18. What should a driver do when approaching a narrow bridge on a rural Indiana road?

    1. Use caution and be prepared to stop for other vehicles
    2. Move left immediately to claim the bridge before oncoming traffic
    3. Keep full speed because narrow bridges have priority markings
    4. Pass any vehicle already entering the bridge
    Show answer

    Use caution and be prepared to stop for other vehicles. Rural roads can include narrow bridges where two vehicles may not have room to pass comfortably. Indiana's manual calls for caution, attention to narrow-bridge signs, and readiness to stop for another vehicle. The sign does not grant a driver priority, and moving left or attempting a pass can turn a limited-width approach into a collision. Reduce speed early enough to see the bridge opening and any oncoming traffic. The practical cue is limited pavement: prepare to yield rather than trying to force simultaneous passage.

19. 19. For a no-insurance suspension occurring after January 1, 2015, what reinstatement fee applies to a third or later suspension?

    1. $250
    2. $1,000
    3. $500
    4. $300
    Show answer

    $1,000. Indiana's post-January 1, 2015 fee schedule increases with the number of no-insurance suspensions. The first costs $250, the second costs $500, and the third and each subsequent suspension costs $1,000. The $300 figure belongs to the older pre-2015 schedule for a third or later suspension, while $250 and $500 belong to the first two post-2015 events. Check the date of the suspension before choosing the amount, since the older schedule is different.

20. 20. When an Indiana registration is renewed by mail or online, how long do plates and stickers take to arrive?

    1. Same day
    2. Approximately 21 days
    3. About 90 days
    4. About 3 days
    Show answer

    Approximately 21 days. The BMV offers several ways to renew a vehicle registration from home, by mail, online at myBMV.com, by phone, or at a BMV Connect kiosk. When renewing by mail or online, plates and stickers arrive in approximately 21 days, and the online branch lets you track their progress. Renew early enough that the sticker arrives before the current one expires.